GG’s:
I’ve posted this before.
There is, or was, a standard for straight screw slots which was based on wire
gauges. If anyone can come up with a reference on this, I would greatly
appreciate it.
The intended scope of the standard is unclear; wood screws, machine screws, or
both. British or US?
Likewise, I can’t recall which of the several wire gauges was referenced.
Scott Grandstaff has it right; the only dimensions which are important are the
slots of the screws you are driving, which may or may not conform to some
standard.
That said, I’d like to grind a set of drivers for the US standard, if there is
one.
John Ruth
In Metuchen, NJ, where it is beginning to snow.
Sent from my iPhone
|