John,

John Crane wrote:
>   2nd wooden vise screws. Has anyone here tapped thier own holes and
>   made thier own screws? Are there any sources for 2 inch screw boxes
>   and taps? I'm not really up to hand cutting screws at this point.
>   Would it just be easier to buy a metal bench screw and hope I don't
>   offend the almighty gallootius maximus?

I haven't seen a source for 2" screw boxes (new, though some of the
dealers can no doubt supply them) , but I used 1 1/2" on my bench and
they seem to work fine. Woodcraft has these.

-Ken