On Fri, Jan 24, 2020 at 10:42 AM Paul Gardner wrote:
>
> I'd do the same with that shiny pan head screw except I'd strip the zinc
> off it with some mild acid over the course of a day or three and give it
> the same heat and oil plunge treatment. Guaranteed to look better than it
> does now.
Vinegar soak is a wonderful thing. Or, if you know what size you need,
some of us have stashes of vintage screws which could be looked through,
but expect Galoot turn around times on that.
As far as parts go, if you've been to mprime, you should have seen this
page, with the drawing. You didn't mention it specifically, so I'll toss
it out.
http://www.mprime.com/Emmert/RogerVM1.htm
RVM (RIP) who wrote this up, did a great job, and his Emmert was a thing of
beauty, say those of us who have seen it. Unfortunately for posterity, I
didn't take any pix when he showed it off in 2000 at the BAGAThon hosted at
his house, and I don't see it in the 2002, expect "closed up" here
https://kirkhmb.smugmug.com/Woodworking/BAGaThons-and-Gatherings/020907
-BAGathon-RVM/i-cWn8tJD">https://kirkhmb.smugmug.com/Woodworking/BAGaThons-and-
Gatherings/020907-BAGathon-RVM/i-cWn8tJD
Also, Carl at MPrime used to sell parts, but I don't see that offered
explicitly anymore.
--
Kirk Eppler, in Half Moon Bay, who hopes to get a bit of shop time this
weekend again.
|