sun, 15-jun-2008, 18:15

sawing the last stair tread

I managed to get a couple projects done this weekend, most notably, a new set of entry stairs for the house. The old stairs were a bit too steep, and the plywood treads were starting to delaminate. I built a new set from 2×12 and 2×6 lumber. The math works like this. You measure the distance from the top surface to the ground and subtract the thickness of material used for the stair treads. The basic rule to help determine the number of stairs for your distance is that the sum of the rise and run for each stair should be around 17". Since I used 2×6’s for the treads, with a small gap in between, the run of each step is 11¼". The distance from the deck to the ground divided by six (one more step than we had before) yielded a rise of 6¼", (6¼ + 11¼ is as close as I can get to 17). Once you’ve got the rise and run numbers, it’s easy to mark out the steps on the 2×12 using a square, remembering to subtract the tread overhang from the run you’re cutting out of the stringers (each notch in my stairs was 6¼" × 10¼" because I have a 1" overhang on each step). Finishing off the stringers means cutting off the top perpendicular to the top tread, and cutting off the bottom so the first rise is the same as the others minus the thickness of the treads. A couple hangers on the deck, a couple concrete piers buried in the ground, and we’ve got a new way into the house.

All hand tools, no electricity was used.

Meta Photolog Archives